pb1
New Member
Posts: 1
|
Post by pb1 on Sept 14, 2024 22:22:35 GMT -5
Anything to watch for with a 3260 with 8.1L? Looking at this as possible purchase. The engine access didn't look stellar but might be ok...? Also, I noticed some water in the engine bay, and when running the bilge for a few seconds there was water.
Is it normal to have water in the bildge, and engine bay?
|
|
|
|
Post by gofast24 on Nov 29, 2024 5:36:12 GMT -5
Yes, the bilge pump and float switch set a inch or two above the actual bottom of the hull so they dont kick in until the water level get up those few inches. Not much you can do and it really doesn't causes any problems. Try pumping out the remaining water with a small hand or electric pump and watch for more water ingress in case you have a leak somewhere. Sorry for the late reply but I have been going through some medical problems for almost a year  |
|
