|
|
Post by seasunofthesoul on Mar 2, 2020 15:40:44 GMT -5
'07 4460, but was the same type of lights I had on my '08 3060 ... the recessed lights in the arch, roof, and interior are 2" in diameter, have a metal ring around a glass lens. I pulled one down yesterday and the lens dropped and broke. Looking to find a replacement and internet searching isn't helping. Anyone have a lead on these?
|
|
|
|
Post by SandLapper on Mar 2, 2020 22:12:15 GMT -5
If its like mine it's frosted. This may be a longshot but....https://www.ebay.com/itm/402074256852
|
|
|
|
Post by goldenarch on Mar 5, 2020 9:58:06 GMT -5
I did the same thing changing out the 'puck light' bulbs to LED...dropped the first lens on floor and broke it. Not sure whether the above lens mentioned by John is the same, but would love to have a couple of them...
|
|
|
|
Post by gofast24 on Mar 5, 2020 11:07:43 GMT -5
I did the same thing changing out the 'puck light' bulbs to LED...dropped the first lens on floor and broke it. Not sure whether the above lens mentioned by John is the same, but would love to have a couple of them... Did the same thing but just bought 4X LED surface mount "puck" lights to replace all the old plastic chrome corroded rings with "push into place" 5 watt LED lights. Had to open the current mounting holes the old lights were installed into about a 1/8" in dia. but the new lamps had two spring loaded clamps and all I had to do was compress springs to push through holes and they snap into place. Also added a 130 ohm 10 watt resistor in series with all 4 lights to dim the arch lamps. Used a unused switch at the helm to "short out" the resistor to allow full voltage to the lamps for full brightness. Works great. |
|
|
|
Post by tc33obx on Mar 15, 2020 8:37:28 GMT -5
GoFast,
Any chance you can share a picture of this change to the lights?
|
|
