gp
New Member
Posts: 7
|
Post by gp on Jul 31, 2023 6:53:07 GMT -5
Hello;
I have a Regal 42SC- waste tank level meter is not working... Needle goes all the way up and then back to 0.
Anny suggestions? The fresh water side works OK - believe the waste sensor is going bad.
Where is located?
Thank You in advance
GP
|
|
|
|
Post by autobahn on Oct 31, 2023 21:00:09 GMT -5
Suggestions:
1) try filling up the waste tank with fresh water from a hose. Fill it up several times and then drain it. I do this at least event time I do a pump out .
2) get a hammer and lightly tap on the top of the tank sender to see if it's stuck
3) visually check wiring
4) replace waste tank sender
|
|
|
|
Post by gofast24 on Jan 7, 2024 8:58:34 GMT -5
Suggestions: 1) try filling up the waste tank with fresh water from a hose. Fill it up several times and then drain it. I do this at least event time I do a pump out . 2) get a hammer and lightly tap on the top of the tank sender to see if it's stuck 3) visually check wiring 4) replace waste tank sender The sending unit can be cleaned by removing the disc on the bottom of the unit. It has a snap ring and after you remove it the float can be removed (pulled out) and cleaned along with the inside of the tube. But, it is a PITA getting the sender out of the tank, especially on our 2001 4160. |
|
